Wind Tunnel 300 x 80mm

Air velocities of upto 45m/sec are achievable in the test section which is accessed by a door forming one side of the section. There is a port in the door used for small model changes and as a means of adjusting models during a test run.. Static pressure tappings are fitted at a number of points in the upper wall and a pitot tube can be traversed at several points. A pitot-static tube is also fitted downstream of the test model. Both probes can be traversed over the full width of the duct. Models supplied with the wind tunnel include a cylinder, aerofoil, boundary layer plate and two model vehicles. 2 & 3 component balances are available and models can be made to order.

Request more information

This field is for validation purposes and should be left unchanged.

Can't find what you are looking for?

Get in touch

Contact us with any queries.

Contact Us